![]() Prep Fluid should be used with air, to chase residual water from trapped locations. METHODS OF USING PREPFLUID TO PREPAIRE FOR COOLANT INSTALLATION It is recommended that a complete system flush be done to not only remove the old conventional antifreeze but to also remove as much sediment as possible and get the system as clean as possible. Prep Fluid is compatible with Evans Waterless coolants and residual Prep Fluid will not compromise anti-corrosion or low temperature protections.įor a correct installation of an Evans Waterless Coolant, follow the instructions on the coolant label or refer to specific instructions available on Note that a complete drain of the radiator, block, and coolant reservoir are always required. Prep Fluid is used to prepare a cooling system for the installation of and Evans Waterless Coolant. This product does not provide the anti-corrosion and low temperature protection of an Evans Waterless Coolant. You should attempt to remove as much old antifreeze and water from the cooling system as possible prior to using Evans Coolant Prep.ĮVANS Prep Fluid is not intended as coolant, use as a flush only. It is not a substitute for thoroughly draining the cooling system and Prep Fluid should only be used after the cooling system has been properly drained. FOR FLUSHING PURPOSES ONLY.ĮVANS Prep Fluid is a waterless cooling system flush designed to remove residual water remaining in the cooling system. NOT INTENDED TO BE USED AS AN ENGINE COOLANT. ![]() Used to flush water from cooling system in preparation for installing Evans Waterless Coolant Evans Waterless Engine Coolant Prep Fluid
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |